Support of Column

Structure and Support

SUPPORT OF COLUMN

Glass plants and pipeline should be supported correctly. To prevent inducing undesirable stresses in the glass, support should be rigid. When supported, glass should be in compression.

Generally, glass plant and equipment are supported in a rectangular tubular structure. This structure is formed of galvenised mild steel tubing with the cast iron fittings which are described in this catalogue. This type of structure provides enough flexibility for future modifications and is strong enough to support a glass unit.

Following rules should be followed while supporting a glass unit in a tubular structure:

1. The structure must be rigid. To give lateral support it must be braced back to the nearest wall or any rigid feature.

2. All glass columns are build up from a fixed point on which whole weight of the column should be taken. If total loads exceeds the permissible limits, counter balance supports should be used to relieve excessive weight.

3. With change in temperature, glass column and tubular structure expands at different rate. Therefore glass unit must be free for vertical movement above the fixed point. Hence, above the fixed point, guides supports should be used to give lateral support.

Structure and Support

SUPPORT OF
COLUMN
STRUCTURE TUBES, GALVANISED
STRUCTURE
FITTINGS
STRUCTURE FITTINGS - BASE
STRUCTURE FITTINGS - COUPLER
STRUCTURE FITTINGS - BEND
STRUCTURE
FITTINGS - TEE
STRUCTURE FITTINGS -DOUBLE BEND
STRUCTURE FITTINGS - DOUBLE TEE
STRUCTURE FITTINGS - EQUAL BRACKET
STRUCTURE FITTINGS - UNEQUAL BRACKET
Structure
Fittings Cross
STRUCTURE FITTINGS - SUPPORT
STRUCTURE FITTINGS - PLUGS
STRUCTURE FITTINGS - STUDS
For
columns
For vessels (IN HEATING MENTLES)
For vessels (IN HEATING BATHS)
For vessels (IN VESSEL HOLDERS)
COLUMN BASE SUPPORT FRAMES